This is a tilted element transducer with 12 degrees of tilt – MUST BE INSTALLED IN A LOCATION WITH A DEADRISE OF 8-16 DEGREES  for proper functionality with the “keel arrow” pointing to the keel.

This is very difficult to find a 170 kHz analog depth transducer for Network-series instruments and any other B&G equipment that uses a 170 kHz transducer. These were originally Maptech transducers but they share the same 170kHz frequency as B&G which makes them perfect for all B&G equipment using a 170khz transducer. These come with a short whip and a 10-foot extension cable to make the total cable run around 14 feet. We have additional extension cables available to increase this length – search “Simrad/Raytheon 7 Pin Connector Transducer Extension Cable”

You will cut the 7-pin plug off of the extension and either splice your existing 3-pin plug to it (for network instruments) or if hard-wiring to a  processor, use the loose wires.

We have pinned out the transducer and extension cable and found the following pin/wire assignments to be correct at the end of the extension cable:

-Depth +: Blue ONLY (do not include blue with white tracer)

-Depth –   : Black AND Black w/white tracer

-Depth Shield: Outer shield

Some transducers are equipped with a temperature circuit as well – this 10k ohm resistance will be found between the outer shield and white wires.

This was a new old stock item from a marine electronics company that went out of business.

Thanks for looking!

Shipping Info: Free shipping applies to items being delivered within the contiguous United States (lower 48). HI, AK, PR, and all other US Territories, and International locations will have shipping calculated during checkout.